Baghouse commissioning will directly affect whether it can be put into normal operation, if handled improperly, bag filter is likely to quickly lose their effectiveness, so do the commissioning of the device must be careful and cautious.

Baghouse test run, should be particularly careful to check the following points:

1, the installation of the filter bag after use if there is out the bag, let go, wear occurs, after commissioning can visually judge the chimney emissions.

2, the rotational direction of the fan, speed, bearing vibration and temperature.

3, pay attention to whether there is condensation of moisture the bag room, ash system is smooth. To prevent clogging and corrosion will affect a host of severe fouling production.

4, air volume and pressure of each test point and the temperature is consistent with the design.

5, adjustment and cleaning cleaning cycle time, this work is an important factor about dust capture performance and operating conditions. Cleaning time is too long, will be cleared off the attached dust layer off, a cause of the leak and damage the bag. If the cleaning time is too short, the dust bag is not yet clear drop off, on the restoration of filtration operations, the resistance will quickly recover and gradually increased, which eventually affect its results.

Two cleaning interval, said cleaning cycle, cleaning cycle is generally desirable as long as possible some of that dust resistance can operate under the conditions of the economy. Therefore, we must dust nature, dust concentration etc. carefully studied, and according to different cleaning methods to determine the cleaning cycle and time, and achieve a better adjustment in the commissioning of the cleaning parameters.

At the beginning of the operation time, often there will be some unforeseen situation beforehand, for example, the new device will appear abnormal temperature, pressure, moisture, etc., causing damage.

Dramatic changes in gas temperature will cause deformation of the fan shaft, causing imbalance, running vibration will occur. Once stopped, the temperature dropped sharply, when it will re-start to vibrate. The best selection of different types of fans depending on the gas temperature.